tag:blogger.com,1999:blog-34011427.post5319331243357835186..comments2024-03-16T10:26:53.460-05:00Comments on Wisdom of the Hands: always something...Doug Stowehttp://www.blogger.com/profile/13003845322415622289noreply@blogger.comBlogger3125tag:blogger.com,1999:blog-34011427.post-50722820942109685082015-08-08T11:42:12.437-05:002015-08-08T11:42:12.437-05:00Also, on my Grizzly, there is very little resistan...Also, on my Grizzly, there is very little resistance in the wheel, even when the table locks are tight. I use Jet planers of a exact type at Marc Adams School of Woodworking and of the 6 planers of that type at the school, the wheels are smaller in diameter and don't show the same tendency to wheel down as I experience on my machine.Doug Stowehttps://www.blogger.com/profile/13003845322415622289noreply@blogger.comtag:blogger.com,1999:blog-34011427.post-78112028429787563042015-08-08T11:38:44.909-05:002015-08-08T11:38:44.909-05:00Yes, the table locks are supposed to stop the tabl...Yes, the table locks are supposed to stop the table from creeping up or down during use. But mine don't. I spent 45 minutes on the phone with Grizzly to get to the root of the problem and then decided to take matters into my own hands.Doug Stowehttps://www.blogger.com/profile/13003845322415622289noreply@blogger.comtag:blogger.com,1999:blog-34011427.post-64845579280564597932015-08-08T10:16:24.006-05:002015-08-08T10:16:24.006-05:00aren't the knobs on the side of the bottom tab...aren't the knobs on the side of the bottom table locks? there are two of them, on on each post, with a bar that runs through the table to the other side posts, with a nut on the end shaped like a wedge. Tightening those knobs should lock the table in place. or at the very least snug them up, it should make it should take the slop out of the machine so that it doesn't move on its own. Billy's Little Benchhttps://www.blogger.com/profile/11263343846928902599noreply@blogger.com